Embedded system trainers give students a complete hardware target with the peripherals already interfaced, so laboratory time goes into writing and debugging code rather than wiring. Naugra Export manufactures and exports the complete range from Ambala, India.
8085 and 8086 microprocessor trainer kits with hex keypad and seven-segment or LCD display, on-board monitor firmware, and expansion for 8255 PPI, 8253 timer, 8259 interrupt controller, 8251 USART and ADC and DAC study cards.
8051 and 8951 trainers, PIC development boards, AVR and Arduino-compatible platforms, MSP430 low-power trainers, and ARM development boards based on ARM7 TDMI, ARM9 and Cortex-M cores. Typical on-board peripherals are a 16x2 alphanumeric LCD, UART interfaces, a 4x4 matrix keypad, switch and LED banks, a 10-bit ADC, an I2C interface and a JTAG debug header.
Boards should provide both serial and USB connection so code can be downloaded and run from any standard IDE, an on-board Flash programming utility, and a master reset key. Every pin marked on the silkscreen saves a great deal of laboratory time.
Plug-in modules for stepper and DC motor control, relay and opto-isolator interfacing, GSM and GPS, Bluetooth and Zigbee, RFID, real-time clock, EEPROM, temperature and light sensors, seven-segment and graphic LCD displays, and traffic light and elevator simulation.
Specify that each unit includes a CD or download with sample project code and programmer software, a full experiment manual with theory and step-by-step procedure, connecting patch cords and a self-contained power supply. Confirm the supply voltage and plug type for your country.
Naugra Export supplies complete embedded systems laboratories including trainers, modules, instruments and manuals for engineering colleges and government tenders worldwide. Send your syllabus or BOQ for a compliant quotation.
